To stop it, set both to 0. This item doesn’t belong on this page. KenC, 2 half bridges get combined to make a H bridge. H Bridge DC Motor. PaulS Brattain Member Posts:

Uploader: Nikot
Date Added: 5 June 2012
File Size: 21.29 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 77800
Price: Free* [*Free Regsitration Required]

Semiconductor Bts7960b Motor Driver 43a H-bridge Drive PWM for Arduino

People who bought this also bought. Thanks Paul, You described the half bridge control which is very clear.

It says to hook logic up with 5v and gnd. The art of getting good answers lies in asking good questions. H Bridge DC Motor.

For both you obviously need to hook up the Vcc and Gnd. There is also an example of H-bridge in page 6. Do I need bts7906b wires from Arduino to control the board? The product works fine but the rated current does not seem to be correct. Yes, I have 2 of this board from ebay too. This driver is for one motor only.

There are 2 ways to wire it, depending on if you want to use the fewest number of outputs, or if you want to use the fewest number of PWM outputs. Set the desired direction to high and the undesired direction to 0. After 30 seconds the motor stops and the controller shuts down, after disconnecting the battery and powering it back up it seems to work again.


Double BTSB DC 43A Stepper Motor Driver H-Bridge PWM For Arduino Smart Car | eBay

To stop it, bts7690b both to 0. The lowest-priced brand-new, unused, unopened, undamaged item in its original packaging where packaging is applicable. With some chips you can also lock the motor in place or make it hard to move by connecting both sides to the top or both to the bottom so the motor is short circuited.

This item doesn’t belong on this page. Defines whether high- or lowside switch mootor activated Pin3, INH: PaulS on Apr 04, See all 2 brand new listings. Skip to main content. They are basically the 2 sides of the Hs, the parts of bts760bwith your load being the. Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag.


I btss7960b apologise for not clear with my purpose. I guess its a thermal safety feature thats shuts down. To control it, use digital write to set the direction you aren’t using to 0, and analogwrite to set the other one to the desired setting. See details for additional description.

Unfortunately, that is not what I am after. I am aware that motors can draw much more current at start-up but even at a constant rpm the controller shuts down. vts7960b

KenC, 2 half bridges get combined bts7960n make a H bridge. I just got 2 of these in: I ordered this for a small motor that should use 20A at 24V, the motor accelerate very slowly.

Why waste forum bandwidth by creating a duplicate thread? Can not handle 43A The product works fine but the rated current does not seem to be correct.

Show More Show Less. Use analogwrite to set the desired speed.