Router config-if tunnel source? Last but not least, we need a crypto map that pulls everything together and we activate it on the physical interface:. Interface that connect to the Border router!! IPV6 is not enabled on this interface Rene. They create a logical path between each end point. East site Internal network.

Uploader: Arashibar
Date Added: 21 July 2013
File Size: 54.54 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 68283
Price: Free* [*Free Regsitration Required]

Explained As Simple As Possible. More Lessons Added Every Week!

How to configure IPv6 tunneling over IPv4 |

You can also configure the tunnel interface between the physical interfaces but I like to use loopback interfaces. Here is a screenshot: Tunnel between BNorth and Beast.

The GRE tunnel interface on the other side, oved keepalives are not configured, remains up even if the other side of the tunnel is down. Without an address, you get an error: Notify me of new posts via email. Each Border router will be configured with static routes to other sites!! Subnet used between BEast and Eastv6. We will call this outer protocol the delivery protocol.

Implement IPv4 tunneling and Generic Routing Encapsulation (GRE) – Eric Leahy

IPV6 is not enabled on this interface Rene. Worth site Internal network. IP tunnels are used within a network to transport one network protocol within another network protocol, typical IP.


Full Access to our Lessons. This will make sure that when a physical interface fails your IGP will try to find another route to the loopback interface of your neighbor. My public key for secure communication: I had a small criticism about Raza when and I known as to ove it.

How to configure IPv6 tunneling over IPv4

North site Internal network. We will call this the payload packet. By continuing to use this website, you agree to their use. BNorth config do ping The inner IP header Source Address and Destination Addresses identify the original sender and recipient of the datagram, respectively.

BEast config do ping Kittens can squeeze into smaller spaces and get stuck. August 17, at 5: But you destination will always need to be an IP address, that the router knows how to get to before the tunnel is brought up.

To tunnel the traffic, the sending router encapsulates packets of one networking protocol, called the passenger protocol, inside packets of another protocol, called the transport protocol, transporting these packets tunenling another router. Regardless of the number of network hops between the source and destination, the traffic passing over the tunnel sees it as a single hop. If you like to keep on reading, Become a Member Tunnelijg We use cookies to give you the best personal experience on our website.


Notify me of new comments via email. Even if the normal egress interface were to go down, traffic across the tunnel could continue to grre, if there is a route to the tunnel destination in the routing table.

One technique that we can use is tunneling. GRE tunnel keepalives timers on each side are independent and do not have to match.

CcieCiscoIpv6. The payload is first encapsulated in a GRE packet.